This article provides some guidelines on cleaning and disinfecting simulators and simulator equipment. WARNING: ONLY solutions permitted to clean avionics screens, genuine or otherwise etc. should be used. Don’t spray cleaners directly onto the item. Don’t get moisture into any openings. Use caution when cleaning polycarbonate lenes covering the CGI (Computer Generated Instruments). Recommendations Frasca […]
Category: Computer
Articles related to the computer system descriptions, maintenance, troubleshooting, and operation.
BIOS Settings on a FPN183750 Computer
This article details the procedures for setting a computer’s BIOS configuration on a FPN 183750 Computer according to CF183750.
Motherboard: Supermicro C7X99-OCE
BIOS Settings on a FPN170393 Computer
This article details the procedures for setting a computer’s BIOS configuration on a FPN 170393 Computer according to CF170393.
Motherboard: ASUS P9X79 WS
BIOS Settings on a FPN154106 Computer
This article details the procedures for setting a computer’s BIOS configuration on a FPN 154106 Computer according to CF154263.
Motherboard: EVGA nForce 780i SLI
GISt Security Board Installation Procedures
Gain access to the GISt/IOS/Combo computer in which the Security Board is installed. Connect the HASP dongle…
Cueing Computer Description
The Cueing Computer runs real-time model, which computes the required frequencies and the motor command that will generate them.
Control Loading Computer Description (ECL3)
The Control Loading Computer runs a real-time model, which computes the control forces for the Control Loading system.
Control Loading/Combo Computer Network Adapter Configuration on ECL2 and ECL3
To check the network connection properties to ensure proper communications with the Trainer Network, the following procedure may be used:
Control Loading/Combo Computer Description (ECL2)
The Control Loading/Combo Computer runs a real-time model, which computes the control forces for the Control Loading system.
I do not have an available Com Port on my Visual PC replacement to control the projector power on/off. How do I fix this?
You will have to install a USB to Serial Converter on the Visual PC to control the power on the projector, then once that is installed the Projector.ini file will have to be modified.