System behavior can be logged using built in data logging capability.
The pneumatic pressure is monitored from the States tab. A sub-section exists for each of the three Pneumatic Arms.
Click the States tab at the top of the Cueing Debugger window. Click the CLR button to the left of the Fault listing section the applicable Actuator.
The Actuator states are monitored from the States tab. This tab contains six Actuator sections, one for each of the Actuators.
The system state can be controlled from the IOS HW Panel on the States tab. The IOS HW Panel functions identically to the Cueing IOS Box
Run and Connect to the Cueing Debugger. Click the States at the top of the Cueing Debugger window.
The system states are monitored from the States tab.
The Cueing Debugger (REL183022) program provides the ability to monitor system operation, inject test signals into the system, and record system behavior.
The Maintenance Mode switches are used to set an axis to Maintenance Mode.
There are three Air Tanks in the system that act as accumulators for the three Pneumatic Arms. The Air Compressor is used to fill the Air Tanks that supply air pressure to the Pneumatic Arms.