Powering up the RTD

1. Verify a complete set of panels are installed. 2. Turn the Remote Power Switch on the front of the RTD to the ON/OFF position momentarily.

Read More

Shutting Down the RTD

Have the flight crew land and perform a normal aircraft shutdown. Turn the Remote Power Switch on the front of the computer cabinet to the ON/OFF position momentarily (if equipped).

Read More

Converting Flight Models on the RTD

Shut down the RTD. Remove the panels by loosening the quarter-turn fasteners counter-clockwise, one panel at at time. Install the panels by aligning each panel with the connector and the quarter-turn fasteners on the panel, and then push while tightening a quarter turn clockwise. Power up the RTD.

Read More

Readiness Page

The Readiness page displays automatically when a system software or hardware component failure occurs on the RTD.

Read More