This article provides some guidelines on cleaning and disinfecting simulators and simulator equipment.
Category: How To
Articles providing how to perform tasks, calibrations, maintenance, and troubleshooting.
How to assign an XGPS Bluetooth Adapter COM port number to the NorthStar application
This article provides instructions to assign the correct COM port number for the XGPS Bluetooth adapter to the NorthStar application.
Configuring Network Card for DHCP on Windows XP
This article provides instructions for configuring a network card for DHCP on a WindowsXP computer.
TeamViewer Setup for Remote Support
This article provides instructions for setting up and using TeamViewer on a Frasca device to allow for remote troubleshooting.
Computer Backup and Recovery Procedures Using Image for Windows/Linux to an External Hard Drive
This article is an abridged guide for Image for Windows/Linux intended as a guide for creating and restoring hard drive images for computers in Frasca products.
ILS Station Localizer Half-Width Formula
This content is restricted, you either do not have permission or need to login.
Lubricating an ADI (Attitude Indicator) FPN700-00087
Remove the ADI from the instrument panel. Remove the ADI casing by removing the two screws located top and buttom side on the rear of the ADI.
Calibrating an Aerobatic ADI (Attitude Indicator) FPN700-00087-002
Remove the ADI from the instrument panel. Remove the ADI casing by removing the two screws located top and buttom side on the rear of the ADI.
Adjusting the dimmer value on the Bendix/King KAS297B altitude preselector.
Press and hold the ARM button (lower left) for at least 5 seconds.
Altimeter Calibration on a Servo Board
Altimeter calibration requires adjustment of the instruments expected minimum and maximum indications using servo board potentiometers. The user can normally adjust the instrument accurately within 50 feet of the IOS indication at all altitudes.