This article provides some guidelines on cleaning and disinfecting simulators and simulator equipment.
Category: CAN Bus
Articles related to the CAN Bus system descriptions, maintenance, troubleshooting, and operation.
Lighting Module Replacement FPN142727
These procedures are for replacing a CAN Lighting Module (FPN 142727).
How to find the Firmware Version for ETC+ Modules, EECL Master Modules, and TruFeel2 Modules
This procedure is used to find the ETC+ Module, EECL Master Module, or TruFeel2 Module Firmware Bootloader and Application Version Numbers.
TruFeel2 Module FPN149024 (ECL2)
The TruFeel 2 Module senses the position of the motor, reads motor torque from the Servo Drive, and monitors load cell output.
Lighting Module Description FPN142727
The Lighting Module (FPN 142727) is typically used to provide panel lighting, which commonly has a high current requirement.
DAC Module Replacement FPN141643 (MK2)
These procedures are for replacing a Mark 2 DAC Module (FPN 141643).
DAC Module Description FPN141643 (MK2)
The DAC or Digital to Analog Converter Module (FPN 141643) is typically used to drive DC resolver or servo instruments. All CAN Bus modules share similar characteristics, this is covered in the CAN Bus System Description article.
Combo Module Replacement FPN185326 (MK3)
Procedures for replacing a Mark 3 Combo module (FPN185326).
Replacing CAN Distribution Board Fuses
These procedures are for replacing the fuses on a CAN Distribution Board.
CAN Distribution Board Replacement FPN120717
These procedures are for replacing a CAN Distribution Board (FPN 120717).