This article provides some guidelines on cleaning and disinfecting simulators and simulator equipment.
Category: TruFeel
Articles related to the TruFeel Control Loading system descriptions, maintenance, troubleshooting, and operation.
ECL Actuator Cable Installation FPN141538
Center the pulley, then hand tighten the Centering Bolts to hold the actuator in place.
Control Loading Actuator Cable Check/Adjustment
Power down the simulator if is running. Locate the Control Loading Actuator.
Control Loading Module FPN139208 (TruFeel)
The Control Loading Modules are identical to the Combo Module, but have different firmware. They handle all the high speed servo loop calculations.
TruFeel Control Loading System Description
TruFeel control-loading system simply simulates a spring, with a variable spring constant, variable dampening, and variable center point. This is done with a closed loop position based feedback and a force sensor to remove the motor back-drive and friction. The servo loop runs at 2Khz, with a real time safety and auto calibration routine.
TruFeel Fault Codes
The quickest way to diagnose a problem in a TruFeel system is usually to start by checking the TruFeel Fault Codes.