This article provides steps for troublshooting issues on the RTD after software updates were installed.
Category: Maintenance
Articles related to maintaining and replacing components on your RTD.
GNS430W Screen Adjustment on the RTD
This article provides the procedures for adjusting the screen position of the GNS430W on the RTD.
RTD Lockable Door Installation
This article provides instructions for installing the lockable door and the power key switch to the RTD.
GNS430W RealityXP License Activation
This procedure outlines the instructions for installing the RealityXP license used for generating the GNS430W’s. RealityXP requires a license file that has to be installed for the GNS430’s to be usable. This file is provided by Frasca International when a GNS430 kit has been purchased after the RTD is first delivered.
Seminole Kit(s) Installation and Setup
This article outlines procedures for installing and setting up the Seminole Kit(s) on RTD’s where the Seminole Kit was was added after the RTD was shipped after the fact. The affected RTD’s are those shipped prior to August 19th, 2019.
Calibrating the Rudder Electric Trim on the RTD
This procedure provides instructions for checking for proper calibration, and calibrating the rudder trim system on the RTD using GriffonCal.
Check/Set IP Addresses on the RTD
This procedure provides instructions for checking for proper IP Address settings on the RTD.
RTD Single Channel Visual Display Configuration CF194226
This article provides instructions on how to reset and configure the TV labeled as FPN194226-1. For detailed information regarding the operation of the TV, refer to the Owner’s Manual.
RTD 3-in-1 Visual Display Configuration CF194002
This article provides instructions on how to reset and configure the TV labeled as FPN194002-1. For detailed information regarding the operation of the TV, refer to the Owner’s Manual.
The RTD IOS No Longer Returns Search Results for an Airport
After a software updated from REL193377 Revision A to Revision B, the Airport search no longer returns any results. This also does not allow the user to select a reference airport. The following instructions show you how to resolve this issue.