This procedure is used to update the Jeppesen Data used on the Host and RTD IOS using DataSync. DataSync allows the Customer to incorporate Jeppesen Data Updates on the RTD.
Category: Maintenance
Articles related to maintaining and replacing components on your RTD.
Garmin G1000 System Databases Update on the RTD (NAV Data, Flight Charts, etc.)
This procedure updates the Garmin G1000 System Databases on the RTD. The procedure below was written specifically for updating NAV Data, however this applies for updating all G1000 System Databases.
GNS430W (WAAS) NAV Data Update on the RTD
This procedure updates the GNS430W NAV Data on the RTD.
GNS430W Obstacle Data Update on the RTD
This procedure updates the GNS430W Obstacle Data on the RTD.
Setting the Initial Startup Position on the RTD
This procedure sets the default airport or location of the aircraft after Powering up the RTD.
RTD Control Wheel Replacement (FPN 193549, and 194864)
1. To replace the control wheel assembly on your RTD, you will need a #2 Phillips screwdriver, and a 3/8” wrench. 2. First, shut down your RTD if it is running, by opening the Computer Door and pressing the Power button on the front of the computer.
Manually Stopping and Starting a Configuration on the RTD
This procedure is used to manually stop and start a configuration using Trainer Controller, mainly for maintenance purposes.
No Video Output on the RTD
The Video Card inside the Computer can become disconnected from the motherboard riser. The following procedure is used to open the Computer and verify the video card is properly connected.
RTD Wi-Fi Router Settings on a FPN192953 ASUS RT-N66W Router
If the RTD’s Wi-Fi Router has been reset, the router must setup to work on your RTD. This article details the procedures for setting a Wi-Fi’s configuration on a FPN 192953 ASUS RT-N66W router according to CF192953.
RTD Wi-Fi Router Shows “Network Cable Unplugged” on FPN192953 ASUS RT-N66W Router
If the RTD’s Wi-Fi Router has been reset, the router must be setup to work on your RTD