This article provides instructions for replacing the FPN193353 Computer on an RTD.
1.Prior to unpacking and setting up your RTD, inspect the pallet and contents for any damage. 2.To set up your RTD, you will need a 7/16” wrench, a 7/16” socket, a 1/4” Flathead Screwdriver, a small level.
This procedure resolves the issue where the Cessna 172 Analog Overlay panel Trim and Flaps indication on the LCD is not fully visible. This applies to the Cessna 172 Analog panel that has the Trim and Flaps decal installed on the instrument panel.
The Trainer Controller Maintenance password can become corrupted if the computer has been forced off or has lost power before correctly shutting down.
WARNING: When the computer is not shut down correctly, files can become corrupted. Each time this happens more files will become corrupted, resulting in having to reinstall windows and the system software, causing unecessary down time.
This article provides steps for troublshooting issues on the RTD after software updates were installed.
This article provides the procedures for adjusting the screen position of the GNS430W on the RTD.
This article provides instructions for installing the lockable door and the power key switch to the RTD.
This procedure outlines the instructions for installing the RealityXP license used for generating the GNS430W’s. RealityXP requires a license file that has to be installed for the GNS430’s to be usable. This file is provided by Frasca International when a GNS430 kit has been purchased after the RTD is first delivered.
This article outlines procedures for installing and setting up the Seminole Kit(s) on RTD’s where the Seminole Kit was was added after the RTD was shipped after the fact. The affected RTD’s are those shipped prior to August 19th, 2019.
This procedure provides instructions for checking for proper calibration, and calibrating the rudder trim system on the RTD using GriffonCal.